Service sheet · Madrid
Electrics & consumer units
Breakers, light points and designer switch plates
Electrical diagnosis and repair in an occupied home: tripping breakers, dead circuits, designer switch plates and decorative light fittings replaced without damaging ceilings or mouldings.
What is included
- Tracing a tripping RCD circuit by circuit.
- Replacing MCBs and RCDs and retightening the consumer unit.
- Sockets, switches and designer plates (Jung, Gira, Berker, Bticino).
- Fitting and replacing light fittings, wall lights and chandeliers with reinforced anchors.
- Dimmers, presence detectors and scene lighting circuits.
- Measurement and verification with clamp meter and insulation tester.
Materials and equipment
- Branded gear (Schneider, Hager, Legrand) and plates matching the existing range.
- Halogen-free cable, quick connectors and junction boxes.
- Chemical or through anchors for heavy, large-format fittings.
- Floor and furniture protection, with dust extraction while drilling.
- Tripping breaker diagnosis: 1-2 hours.
- Socket or switch change: 30-45 minutes per point.
- Light fitting installation: 45-90 minutes.
- Full consumer unit replacement: half a day, by appointment.
- Scheduled job (first hour)
- €65
- Emergency, response within 4 h
- €85
- Additional hour
- €45
- Socket or switch change
- €65-90
- Light fitting installation
- €65-120
- Consumer unit replacement
- €450-900
Indicative prices, VAT not included, first hour of labour included. Additional hour €45. Materials at cost + 15% with the supplier invoice. No call-out charge inside the M-30; €20 up to the M-40. The final price is confirmed in writing before we start.
We do not carry out complete new-build electrical installations or certification for properties with no existing installation. Appliances under warranty go to the official service.
Need a fixed price?
Send measurements and photographs through the quote form and you will receive a written assessment within 24 working hours.